The alarm operation is a function of the body control module. I'm not aware of any owner procedure to disable it. You could disconnect the horns, but that creates other problems. If you lock the car manually with the locks on the window ledge, NOT the electric switch, NOT the remote and NOT with the key, the alarm system is not supposed to activate and should not trigger. The red light on the dash will not be flashing if the alarm is not set. It isn't a perfect solution but it may be a workaround.
Unlocking the doors with the key is supposed to shut off the alarm. Have you tried that?
Do your remotes work consistently for other functions? Maybe the batteries are getting tired.
24 7 Locksmith Williamsville Ny 716 200 1030 Locksmith Williamsville Ny
SOURCE: 2005 Chrysler Grand Voyager. Central locking
the body control module may need a software update..check with your local dealer
SOURCE: programming instructions for a 1999 Chrysler 300M remote fob
Manual Programming Procedure (non scan tool)
1. Connect pin 1 of the 16-way data link connector to chassis ground or to pin 4 of
the 16-way data link connector.
2. Close all doors, turn ignition key to off.
3. Turn ignition key to Accessory.
4. Turn ignition to off, door locks will cycle once (in programming mode).
5. For each key FOB, press any button 3 times in a row to program code. When
programming is complete, the door locks will cycle once.
NOTE:
IF A SECOND KEY FOB REQUIRES PROGRAMMING, IT MUST BE PROGRAMMED WITHIN 1 MINUTE OF
PROGRAMMING
THE FIRST FOB PROGRAMMING. PRESS ANY BUTTON ON THE SECOND FOB 3 TIMES TO PROGRAM ITS CODE. WHEN PROGRAMMING IS COMPLETE, THE DOOR LOCKS WILL CYCLE ONCE.
6. The programming mode finishes after the following:
a. Programming of two key FOBS is completed.
b. One minute has passed since programming.
c. Pin 1 of 16-way data link connector is removed from ground connection.
d. Ignition switch is turned on.
e. Any of the doors are opened.
SOURCE: I need a free owners manual for a 2000 chrysler 300M
There will be a few minor differences between the 2000 and 2004, but for the most part, you can use the 2004 manual as a reference. Since it is illustrated, you can confirm visually when you are taking on repairs. I have owned a 2000 300m for several years. Might I recommend you visit 300mclub.org? I am a member there and have learned a ton about 300m's.
SOURCE: need to find starter on 2000 chrysler 300m
The starter is under the car on the left side by the oil filter. You will need to take off the oil filter, the motor mounts, and then take the starter off, their are 3-4 bolts holding the starter on, the hardest one to get off is the one on the top . You will need a swivel to get the top one off. It will take about 3 hrs or so as long as they give you a good starter at the store.
SOURCE: Cd System in 2000 Chrysler 300M
Had same problem wit my 4 disk. A CD was jammed. Remove and open the unit up and remove the CD. The mechinizem might be jammed also. Try this before replacing. Seems like a common issue with these units. The newer 300Ms came with 6 disk changers.. not sure if these will work with the existing radio.
Good luck!
216 views
Usually answered in minutes!
×