Where is the a reset inertia switch for fuel and where is it?

The inertia switch, also known as the fuel cutoff switch, is typically located in the cargo area of the vehicle, behind the trim panel or carpeting. Here are the general steps to remove the inertia switch from a 2004 Ford Expedition:

1. Turn off the engine and remove the key from the ignition.
2. Locate the inertia switch in the cargo area of the vehicle.
3. Disconnect the negative battery cable to ensure the switch is not live.
4. Press the release button or tab on the switch to unlock it from its bracket.
5. Gently pull the switch out of its bracket and disconnect the electrical connector from the switch.
6. If you need to replace the switch, install the new switch by reversing the above steps.

It's important to note that some Ford models have a reset button on the inertia switch that can be pressed to reset the switch instead of completely removing it. If your Expedition has a reset button, it may be worth trying that before attempting to remove the switch.

I looked at owners manual for 03 ford f150, found this picture for inertia switch location.

You probably had your alarm set when you took out the old one. Just unlock your doors with your key fob, then disconnect the battery again for a few minutes and let it reset with the alarm off.

Hey Carlos , does your vehicle run ?
Fuel Reset
The FUEL RESET indicator is grounded through the inertia switch whenever the vehicle is subjected to a high force situation. The inertia fuel shutoff switch (IFS switch) (9341) cuts off the fuel pump motor. The FUEL RESET indicator illuminates when the IFS switch has been tripped.

Fuel Reset
The FUEL RESET indicator is grounded through the inertia switch whenever the vehicle is subjected to a high force situation. The inertia fuel shutoff switch (IFS switch) (9341) cuts off the fuel pump motor. The FUEL RESET indicator illuminates when the IFS switch has been tripped

Your best bet , take it to a qualified repair shop .

Power goes from the fuse box to the fuel pump relay to the inertia switch and then to the fuel pump motor.I would suggest bypassing the inertia switch for now just to see if you can get the vehicle started and go from there. FYI The inertia switch is just there in case you get in a collision and shuts fuel off. Good Luck

Hello! When you say does not start; Does the starter motor crank?...If the starter motor cranks the engine the anti-theft is clear...If such is the case, lets eliminate the Inertia Fuel Shut-off Switch...The inertia fuel shutoff switch is located on the LH side lower back panel in the luggage compartment and is manually reset...To reset the inertia fuel shutoff switch; press button on top...Send a comment...Guru...saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Very simple, Ford's use inertia switches. They shut the fuel off when you are in an accident. Just call ford and ask for the location of the inertia switch on your vehicle. You just push it in to reset it.

Good luck