What is the torque for inner tie rod end on a 2000 for focus

• Axle Shaft nut - 177 ft-lb
• Hub and bearing assembly to steering knuckle bolts - 133 ft-lb

2003 chevy silverado 1500 4.3 v6. Changing steering rack and

https://www.justanswer.com > ... > Chevrolet Repair
Jan 11, 2021 - Below are the torque specs you requested: Steering Rack-to-frame mounting bolts: 136 lb. ft. Outer tie rod nut: 37 lb. ft. Outer tie rod ...
1 answer · 1 vote: Coupler clamp bolt to the intermediate shaft: 33 ft. lb.

• 
  

  Torque specs for tie rod end castle nuts - JustAnswer

  https://www.justanswer.com > chevy > 2p3g8-torque-sp...
  Oct 24, 2009 - Tighten the clamp nuts 18 ft. lbs. (25 Nm) (except C3HD). On C3HD models, tighten the clamp nuts to 65 ft. lbs. (88 Nm.

People also ask

27 ft lbs

https://www.instructables.com/Replacing-an-Outside-Tie-Rod-on-a-Honda-CRV/

44-59 lb. ft.

Here is the inner tie rod end specs

Tighten the inner tie rod to 100 N.m (74 lb ft).

Should be just one ugga dugga

Does this include the outer tie rod nut also to be 45lbs foot torque?

if its the outer tie rod than loosen the jam nut on the threaded part of the inner tie rod. You will then be able to unthread the outer tie rod from the inner. Count the number of turns and install the new one with the same number of turns.

If its the inner tie rod you will need an inner tie rode remover/installer tool and a torque wrench.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Here are the tie rod end nut torque specs:
• Lower Control Arms - (Front and Rear bolt) 129 ft-lbs x2 and (Knuckle Stud) 37 ft-lbs
• Upper Control Arms - (Front and Rear bolt) 140 ft-lbs x2 and (Knuckle Stud) 37 ft-lbs
• Inner Tie Rods - 81 ft-lbs
• Outer Tie Rods - (Knuckle Stud) Tie Rod nut 44 ft-lbs and jam nut 55 ft-lbs
• Stabilizer Links - 17 ft-lbs
• Rear Shocks - Lower and Upper 85 ft-lbs
• Front Shocks - Module Bolt x2 37 ft-lbs, Module nut x3 37 ft-lbs and Stud nut 37 ft-lbs

I looked in an old Motor book, competitor to Chilton, and it gives no special torques or instructions for front end parts. It just says tighten.From experience I always tightened them with a 3/8 socket wrench until they stopped turning using just my arm strength. Never loosen to put in a cotter pin. Hope this helps.

45 Ft-lbs Tie-rod balljoint stud-to-steering knuckle nut, and 55 Ft-lbs Tie-rod (outer)- to- inner jam lock nut