The starter can only be at 2 points.
the left side or right side of engine
just the most casual looking finds it.
v6, what displacment? gas or diesel?
2.3 L 4ZD1 I4
2.4 L C24SE I4 (GM, Aus)
2.4 L C24NE I4 (Euro)
2.6 L 4ZE1 I4
3.1 L LG6 V6 (GM)
3.2 L 6VD1/6VD1W V6
2.5 L 4JA1 diesel I4 (Cameo, TH)
2.8 L 4JB1-T turbo diesel I4
3.0 L 4JH1-T turbo diesel I4
3.1 L 4JG2 turbo diesel I4
which one?????? omg....
to learn about your engine, use the real name, above is list of all
used world wide (USA smaller list but you never said)
my guess is the GM LG6 common in USA.
using GOOGLE,
and searching for LG6 and starter
i land on this GM site.
http://parts.nalleygmc.com/showAssembly.aspx?ukey_assembly=399286&ukey_make=1024&ukey_model=14523
Left side..... am i lucky>
why not just look........ it has this HUGE cable copper wire to the battery, that is the dead givaway and the cylinder ship... too.
SOURCE: i need diagram for 2.2 l for isuzu rodeo timing
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
CLICK on the following 2 LINKS. They have the Serpentine and Timing Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies:
For the Serpentine Belt:
http://www.2carpros.com/car_repair_information/year/1998/make/isuzu/model/rodeo/1998_isuzu_rodeo_drive_belt_routing_diagram.htm
For the Timing Belt:
http://www.2carpros.com/car_repair_information/year/1998/make/isuzu/model/rodeo/1998_isuzu_rodeo_timing_belt_diagram_marks.htm
SOURCE: NEED DRIVE BELT DIAGRAM FOR 2000 ISUZU RODEO
Here is your diagram. Good Luck and say thanks..lol http://www.2carpros.com/car_repair_information/tec_info/2000/isuzu/rodeo/2000_isuzu_rodeo_drive_belt_routing_diagram.htm
SOURCE: where is air cabin filter located on 99 isuzu rodeo?
its usually behind the glove compartment in the blower box. you will have to pull the GB door down all the way to access it
SOURCE: Crank Sensor in 94 Isuzu Rodeo
it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
SOURCE: needing a wiring diagram for a 200 isuzu rodeo
try http://www.etrailer.com/faq-wiring.aspx. This should help. Mike
1,014 views
Usually answered in minutes!
×