probable that is the cause
there should be no play in a wheel bearing ans if it has then the brake application will make the rotor react all over the place
while the bearings are being replaced , have the rotor checked in a brake shop for warp
we dont have Jackaroo here in USA. sorry! we are USA forum no Holden's here, ever)you in Australia?NO actual V6 stated, which one of the 3? size v6 and , cam count per head, and fueling system there.NO photo of engine posted, and bam , there it is and fueling parts, all clear as DAY to me.it's a no start. the fuel feed line goes to the pump, why not just look at this line see where it goes? no?cam belt fresh, spark plugs fresh? fuses good, no start?here watch scottyhttps://www.youtube.com/watch?v=064Ilsz8Fzg&NR=1&feature=fvwpthe word PETROL gives you away as does JACKaroofuel systems.CARBTBIMPImost are in the tank, but not so on all carb engines sold world wide.lacking what engine is there, and what fueling system , why post to USA forum >?all you will get is,wild guessing.wrong answers.and OFF TRACK .or like I do, generic MR. OTTO CYCLE Gas engineanswers (pure physics)if all want is wild guessing, you are on the perfect forum for that.why not use 0Z forums after all only they haveHOLDENS (this type)http://www.ozisuzu.com.au/index.php?PHPSESSID=a1bfa9361f3344d90a9b2c5cb3bc7903;wwwRedirectever search here is one search.https://duckduckgo.com/?q=australian+isuzu+forum&ia=websee all those and not one land in uSA forum.oddly, ?
which engine..
stalls only at idle. but does fast right foot save it/?????????????
the same answer for gas engines.
there 3 causes in physics, called basics in SCHOOL.
1 to 10 tests using physics evidence
or 50+ causes,,,,,
and last statistics (engines do what the want, not by me)
guess: top reasons
1:never had tuneup full this decade. wins top honors...
2: EGR stuck open.
and 48 more. wana guess or test.
got tools>/?
ever heard of the 60k miles tuneup,? see all this things there.
in the operators guide?
Your problem may be as simple as a bad ball joint, CV joint, tie rod end, hub assembly or other front end part. Something is not tight anymore. Have the front end checked and go from there. GOOD LUCK FRIEND.
disconnect the battery and hop below the vehicle you will be able to see it bolted on to the bell housing. remove the main power wire then the other smaller wire to the solenoid . then remove and replace the starter in the reverse process all should be good