If the clutch is a cable type, crack the 2 nuts either side of cable keeper, make adjustment by winding out the nut and the cable thread, move the cable until firm, then bring the other side nut up and tighten, if its hydraulic, find bleeding nipple, locate resivior, off cap, have another person keep the fluid level to the max line on resivior ,
then get him to pump the clutch pedal, pump it a 4 times, and hold down, while pedal is down, you crack the nipple a little & look for air in the fluid coming out,once the pedal is on the floor, do up nipple . repeat this until the pedal has good pressure. the nipple will be a small brake/ line spanner, AFE, aprox 5/16/ 3/8 etc or metric 8, 9, 10 mill,.
SOURCE: 1992 mercury topaz
I had the same problem. It was the idle air control valve. It sits on top of the intake just downstream from the throttle. There's a valve rod inside that gets worn over time and starts to stick. If that's what is causing your problem, you need to replace the unit.
SOURCE: need stereo wiring codes for 1992 mercury topaz
1991-92 Mercury Topaz Stereo Wiring
Constant 12V+
Green/Yellow
Switched 12V+
Yellow/Black
Ground
Red/Black
Illumination
n/a
Dimmer
Blue/Red
Antenna
Right Front
Front Speakers
6 1/2" Doors
Left Front (+)
Orange/Green
Left Front (-)
Black/White
Right Front (+)
White/Green
Right Front (-)
Black/White
Rear Speakers
6" x 9" Rear Deck
Left Rear (+)
Pink/Green
Left Rear (-)
Pink/Blue
Right Rear (+)
Pink/Blue
Right Rear (-)
Green/Orange
Robert
Please take a moment to rate this solution thanks
SOURCE: fuse diagram for 1992 Mercury Topaz
I have the manuel for the fuses. It`s for a 1992 mercury topaz. If you haven`t found one yet, if you email me I can scan it and get it too you. my e-mail is [email protected]
SOURCE: oil leaking in front of my engine above the oil filter. '92 mercury topaz GS, 2.3 4 cyl
possibly the oil pressure sending unit- looks like a small spark plug screwed into the engine with one wire going to it
109 views
Usually answered in minutes!
×