Where is the EGR valve on a 2003 Mitsubishi Outlander 2.4 liter engine located?
SOURCE: where is my egr valve
Oks it should be close to fire wall it looks around 3 inches oval shaped and has 2 bolts in it and has a gasket plus it has a wired connector to it so you should replace the gasket after you clean it/ so tak it out and use carb cleaner any kind / Put an ew gasket on after you klean it and plug it back in try that/ Please rate my response/ Thank you very much
SOURCE: EGR Valve needs cleaning or replacing
The link below is a diagram of the EGR valve. Looks like a mushroom with vacuum lines attached.
http://www.chiltonlibrary.com/content/images/8666/images/86664018.gif
Instructions:
I hope this answers your question. Best of luck.
Greg
SOURCE: Where is the EGR Valve located on a 2004 Galant
It is on the firewall just behind the engine, to replace it you need to detach the
vacuum hose, remove the two EGR valve mounting bolts, remove the EGR valve from
the intake manifold and then put in the new one.
Thanks for using FixYa - a good rating is appreciated for answering your FREE question.
SOURCE: how to install egr valve on 2000 mitsubishi mirage
To install:
The EGR valve is retained to the intake manifold with two bolts.
SOURCE: p0401 egr flow insufficient
The EGR valve is usually to the right side of motor triangular shape which has 3 screws.There is a metal pipe coming underneath which send excess "smoke" thro it. It tends to carbon up so needs to be cleaned.There are also 3 "pintle valves" on springs inside and the springs could be weakened/carboned up causing the valves to remain open/shut.
2,124 views
Usually answered in minutes!
×