How to remove center console
Hi Rich, hope you well today here's is the fix you need.
23 - Body/Interior/CONSOLE, Center/Removal
REMOVAL
[img id=LOPTableImg src="https://w05.dealerconnect.chrysler.com/service/mds2002/common/images/collapse.gif"> Click to display a list of Labor Operations associated with this procedure
1.
Pull back on parking brake (5) to the upright position.
2.
Open console door and remove two screws (1) fastening console to rear floor bracket (3).
3.
Carefully pry up until the retainers (1) disengage from the center console to front floor bracket (6).
4.
Disconnect center console wire connector (2) to instrument panel connector.
5.
Remove from vehicle.
Hope this help and have an awesome day Rich.
SOURCE: How do remove the rear lens cover on the tail
The lens covers dont come off. You can access the bulb from inside the trunk. By opening the panels
SOURCE: how replace alternator dodge caliber 2008
there is a lengthy list on google of how to go about doing this.
SOURCE: How do you remove a dodge caliber serpantine belt?
take an 11/16 wrench and turn tensioner pulley towards cockpit then slip the belt off of the top idler pulley
SOURCE: How to check transmission fluid level on a 2008 Dodge Caliber
if its a cvt transmission... it has no dip stick cause it has no transmission fluid... transmission is run on 3 belts internaly
SOURCE: how do i reset the
This should automatically reset upon proper tire inflation. If you are still getting a low pressure light then the RF chip in the tire is faulty and needs to be replaced. These are rather expensive and can be purchased from dodge.
940 views
Usually answered in minutes!
×