Does anyone have good pictures of the shift lock bypaas button for Audi A6

SOURCE: 2005 a6 jump starting

I found the battery myself. All of the responses were incorrect as to where the battery was located. Everyone said it was up front but in my car, it is in the trunk. I got the problem fixed myself.

SOURCE: AUdi A6 gas tank button

There is no button to open the gas door from the inside of the car.  As long as the doors are unlocked, you should be able to push in the far right side of the gas door and the left side will pop open. I too spent hours looking for this non existent button..I went as far as to going back to the car dealership.

SOURCE: Shift Lock Solenoid has (had) me locked in Park in my 2002 A6

ok what breaks on most of these shift interlock shifter ***. is where the interlock cable attaches to the shifter assy. chrysler has the same prob. cheap stuff. no i don't think you can fix it as when it was new it already was junk. call a junk yard or try to get one off ebay. and yes they are very easy to replace. goodluck

SOURCE: how to remove audi a6 wiper blades

The problem with this wiper blade set up is the slides get jammed up w/ crude.  You should lubricate the slides and they should slide off.  Then carfully lift the arm and remove the blade.  Warning you should never leave the arm in the upright position.  Windshields get cracked this way.  Also note the pivit points the blades attach too.  These will normally sieze up and cause clearing issues even with new blades.  Lubricate these pivit points and use a pair of channel locks to move it back and forth until it will go 360 degrees with your fingers.  Install is in reverse order of removal. 

SOURCE: i need a wiring diagram for an audi a6 towbar electrics, can anyone help? please email [email protected]

The best solution is to use a Vehicle Specific Wiring Kit, as these cars have complex electronics that do not like being overloaded, Also the car has towing specific safety systems (such at Trailer Stability Program) which only work if it knows it is towing. The car will need to be coded to recognise the towbar wiring and work the saftey systems properly after the kit has been installed. It's not cheap however, Expect to pay around £200-£250 for the whole job.