CHANGE THERMOSTAT IN 2000 ACURA RL

SOURCE: cooling fan for acura tl 2000 does not work

If you can locate the temperature switch, looks like a large bolt head with 2 wires on it, bridge the wires on it, and this should make the fan work. If the fan works then this switch is faulty. If the fan doesn't then it could be the fuse, or a broken wire.
The fan switch is either on the radiator or on the thermostat housing.
If you can get to it easy, short across with a screwdriver.

SOURCE: Heater/Cooling problems on 2000 Acura RL

Check the fuse for your blower motor if it is OK the Blower Motor may be bad or you may have a loose wire to or from the it have it checked if fuse is good

SOURCE: 2000 Acura RL and 2000 Acura Integra GS ABS light on

The SRS computer needs to be reset, if you dont have a repair manual i would first suggest finding one for each car. The basic principal is that you jumper the diagnostic plug (under the glove box in the RL). The next step I believe is that you must depress the TCS button, then while holding it down you turn the key to on, continue to hold the TCS button for 15 sec and then let off. The check engine light should then blink really quick a few times and that means its reset. Im reciting this from memory so dont quote me on it. I have done it before for the RL but not the integra, id really suggest finding a repair manual though.

SOURCE: How to remove factory radio acura rl 99

the best and safest way to remove this radio is with the special tools that Acura made specifically for removing the radio. Any radio store or best buy can easily remove it for you. I hope this helps please rate this and thank you.

SOURCE: instaling a starter on a 2000 acura rl

Fairly hard. Tech time is around 4.5 hours

1. Raise the coolant reservoir, then remove the battery and battery base.
2. Remove the alternator belt and alternator.
3. Remove the left exhaust manifold cover.
4. Remove the left damper fork.
5. Disconnect the left suspension lower arm ball joint.
6. Remove the left driveshaft
1. Remove the transmission stop collar, then remove the exhaust pipe A.
2. Remove the front mount mounting bolts.
3. Attach the chain hoist to the engine.
4. Remove the left engine mount bracket.
5. Disconnect the starter cable and BLK/WHT wire, then remove the starter.