- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
TPMS sensor reset
usually, they reset themselves...
turn your ignition key to ON, then back to ACC or LOCK and wait 15 minutes.
after 15 minutes start the car and drive it at at least 16mph for 10 miles or so, and the light should go off
Jump the battery. If it gets to low, the solenoid for the key won't work and release the key. Just a note. If it is that low replace the battery. Have it checked first, but most likely dead.
does your vehicle have central locking ? if so the rear door lock solenoid isn't working,when you say rear door do you mean the back hatch door ?sorry obvious question but does it have a key lock ? if so is that what will not work ?Without being able to see vehicle it's about asking questions to narrow down the problem , post back if you can give a more precise description of the problem
Try spraying some penetrating oil into the key hole. If that does not help you will unfortunately have to replace the lock part of the ignition. To do this you have to strip all the cowling around the lock, insert the key and place it in the ACC position (most probably but could be another position). Look for a tongue or dowel that can be depressed so that the lock section can be pulled out of its housing.
Programming When Remote control added or replaced. System malfunction. How Obtain all remote controls. Remove key from ignition switch. Close all doors. Open driver's door. Carry out the following within 24 seconds: Turn ignition switch ON and back to LOCK position 3 times. Remove key. Press and release driver's door courtesy light switch 3 times. Ensure doors lock and unlock. If not, wait 40 seconds and repeat procedure starting with driver's door already open. Press each remote control lock or unlock button twice. Ensure doors lock and unlock after each remote control operation. If not, proceed as follows: Press and release driver's door courtesy light switch once. Ensure doors lock and unlock twice. Repeat procedure starting with driver's door already open. NOTE: A maximum of 3 remote controls can be programmed.
×