Ran fine earlier and went out to drive it and wont turn over or anything dont have any lights and the red theft light under odometer is blinking when key is on position fuel pump still kicks on
when they installed the alarm they also in stalled a valette switch on your ride this is to shut off the alarm im looking for the site for your remote that has the way to get your code back in but for now find the valette switch which can be under dash or right side driver kick panel you might have to hold the vallette switch for 5 seconds till it goes off i will post the other solution once i find it for you
SOURCE: 2005 ford taurus. Remote entry wont work theft light keeps blinking when key is engaged
HI, I'm reading your problem,
Let me explain something about your car.
2005 Ford Taurus, The key on that car has Chip inside of the key and receiver on the ignition switch,
Check if the key you are trying to use is Black and has a plastic head.
If not you need a key with that characteristics.
But if you have the right key, Remenber if you had drop on the floor, or hit with something,
Because some times they come damaged, with insignificat thins.
Remenber if you left the key close to a magnets like speakers.
If nothing aply at your case, you need to call a place Aloha Smith, they have the computer to program or reprogarm your key. IF not you can't start your car.
OK.. I hope this information work for you.
Thank's for submit yous question on fixya.com
SOURCE: dont know how to reset or bypass gm theft system car is not starting .It tries and quits.
this is one way to reset it :
first make sure the battery is fully charged , then do the following:
key in the ignition but do not crank the motor, just leave it at the
ignition mode for ten minutes ,then turn it off POSITION for 5 seconds then REPEAT again 2 more times. at the 3 rd time youre gonna notice the ANTI THEFT light on dash to blink. when doing the last step , remove key , inserted again and turn on motor , good luck , AJ
SOURCE: 2002 PT Cruiser CRD theft alarm light on
TRY REMOVING IOD(IGNITION OFF DRAW)FUSE FROM UNDERHOOD FUSE BLOCK FOR 30 SECONDS OR SO..IT SHOULD RESET IMMOBILIZER MODULE..IF THE SAME,REMOVE COVERS FROM AROUND STEERING COLUMN AND CHECK WRING NEAR IMMOBILIZER MODULE..FOR BREAKS,PINCHED WIRING,ETC...HAVE YOU TRIED ANOTHER KEY?YOU MAY A BAD TRANSPONDER IN KEY..;ET ME KNOW IF THIS HELPS
595 views
Usually answered in minutes!
×