Have abs and trac light on and won't go off. Hooked scanner up and found that left rear sensor was throwing code. Car does not run at the moment due to other engine repairs. So spun the left rear wheel manually and read nothing according to the scanner. So jacked up right rear and spun it and it showed up as left rear wheel speed. Checked both sensors with voltage meter and both read voltage up as we spun them. Checked readings with voltmeter at abs module and they read right. Also has a wheel bearing maybe out on front right if that makes a difference. Any ideas?
SOURCE: 98 toyota tacoma abs problem
The ABS and air bags work together on startup untill the lights go out, this is OK.
If the light stays on then you may want
to get checked out.
SOURCE: does front end bearings and abs sensor module
yes ...wheel bearings are on all vehicles as well as nowadays (ABS) is installed on most all vehicles
SOURCE: I recently replaced the passenger front abs wheel
After a while the light will go off. but autozone should have cleared it for you. If you bought the part through them.
SOURCE: rover 75 no speedo and abs light on intermittent
the speedo drive is on this wheel the sensor is on top of the diff output driveshaft ,test the abs sensor with a multimeter for continuety and the connector plug,does the roof vibrate on this one or did the robot work ok on that shift when it was built
SOURCE: 2001 buick park avenue ABS wheel speed sensor replacement
what you wont to replace ABS or speed sensor.
83 views
Usually answered in minutes!
×