Where is cabin air filter located
Then cabin air filter is located right behind the center stack where the radio and heater controls are. It is fairly easy to get to. I changed mine myself without even taking the glove box out like it says. It's a tight fit but doable. There is small door on the passenger side of the center stack. Open that up and the filter is right behind it. There are videos on YouTube if you are unsure of where exactly it is located. It is the same for years 2007-2012. I have a 2012.
SOURCE: cabin filter 2001 xterra
Remove glove box and in cabin microfilter door will be right there. Note on some Xterras there is no filter installed and the box will need to be cut out in order to install kit. This is a fairly easy task that can be done in the vehicle. Just follow the directions and you should be ok.
SOURCE: in cabin air filter
its most likely located behind the glove box. which usually comes unhinged fairly easily from its open position stoppers. then there would be an access panel to remove to get to filter(s)
SOURCE: How to remove and replace cabin air filter 2007 se crew cab
If you haven't figured it out yet, try the two links below. They have pics and diagrams. I haven't done this yet but, Nissan suggesting to have it done. (Sitting in the dealer having oil changed as we speak. They want $90 to replace the 2 filters.) I'm planning on doing it myself to save about $70. Doesn't look too difficult - just a little time. Parts are about $22 at local parts store. hope this helps. (Won't be back on this forum. So won't see any response you submit back).
http://www.clubfrontier.org/forums/f23/cabin-air-filter-replacement-29892/
http://www.nissanhelp.com/diy/altima/projects/nissan_altima_in_cabin_filter_replacement_procedure_1.htm
SOURCE: I need to replace my Nissan Quest 2007 in cabin micro filter
I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.
Testimonial: "Finaly I found the air flow door with three screws and removed it. The filter will need replacement soon. It is been replaced one time at the dealer."
SOURCE: Cabin air filter
Open the glove compartment remove all the screws on the top of the compartment and two screws at the bottom remove the compartment there are two filters standing upright pull them out and replace.
403 views
Usually answered in minutes!
×