Accura 2003 model 3.2 cl

The pump is in the fuel tank.

You would need to contact a dealer for that info. They will need the VIN as well as mikeage. Most recalls affect specific vin and have a mileage limit

This means a fault exists in the transmission, you now need it tested for fault codes.

Have it scanned. Transmission problems when they flash.

At the door jam,check the condition of the pin switch. The switch may be cover with a boot.
Compare the condition of this pin switch to the working side.
Clean the general area and re-test.

You might want to take your car to Autozone and have them perform a free scan to bring a code and give a starting point.

go to www.automecanico.com and look how to proceed, however this site in spanish, you can translate have a complete a powerful information for fix it any car and model, try it.

God bless you

Immobilizer brake code for my accura 2.3 cl ? I dont have the money to have the dealer ship to do it? Or is there some type of sequence I am not aware of that would help the green flashing light on my dash to go off?

This is not easy. Look at the Cl brake blog by P48. You can get the rear caliper piston in the fully retracted position with a home-made tool to twist it clockwise. It is like a large "X". Make sure it is retreating into the body of the caliper which will allow the "thick" new pads to sandwich onto your (new) rotor.

There is a known issue with the ignition switch on the 98 Acura CL 3.0. The ignition was recalled by the manufacturer. This happened to my 98 CL as well. Since it was a recall, Acura may replace the ignition switch for you at no cost, not sure though as they announced the recall in 2003 I believe.