Question about 1999 Lincoln Town Car
Code of P0455 how would i fix this? slight loss of power upon take off, but no other noticible problems.
P0455 - EVAP Control System Leak Detected (No Purge Flow or Large Leak)
The PCM monitors the complete EVAP control system for no purge flow, the presence of a large fuel vapor leak or multiple small fuel vapor leaks. The system failure occurs when no purge flow (attributed to fuel vapor blockages or restrictions), a large fuel vapor leak or multiple fuel vapor leaks are detected by the EVAP running loss monitor test with the engine running (but not at idle).
For DTC P0455 still present: Go to HX44 .
Otherwise, INFORM the vehicle owner that it is important and necessary to immediately install the fuel filler cap after every refueling event. HX44 DTC P0455: VISUAL INSPECTION FOR SUBSTANTIAL EVAPORATIVE EMISSION SYSTEM LEAKS
Note: When checking for leaks or blockages in the EVAP system, energize (close) the canister vent (CV) solenoid through the scan tool for a maximum of nine minutes per pinpoint test step. Then de-energize the CV solenoid prior to performing the subsequent pinpoint test step. This is done to assure proper closing of the solenoid.
Does the pressure on the EVAP system stay above 1.99 kPa (8 in-H 2 O) and pass the leak test?
GO to HX46 .
REMOVE the EVAP System Leak Tester from the evaporative test port and REINSTALL the test port cap. GO to HX50 .
Posted on Apr 16, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
EVAP evaporative emissions systems monitoring
This system includes the on-board refueling vapor recovery (OVRV) system with leak detection (LDP) pump.
The ORVR system filters fuel vapor through the EVAP canister to prevent vapor escaping directly into the atmosphere.
The engine Control Module (ECM) determines when appropriate conditions are met and activates the LDP to pump a small amount of air pressure into the fuel tank and lines. The pump runs until a pre-determined pressure or time is reached. If the system does not hold the pressure, a fault or DTC is stored in the ECM.
The area this is located is behind the right plastic rear wheel liner cover. You will see the fuel filler neck from there and the rest of the EVAP system. Visual check for cracks on all the hoses specially the hose clamps. There are 3 lines connected to the Activated charcoal canister (EVAP canister fastened to body) that are detachable and use O-rings for secured sealing. Check if O-rings, if damaged, replace.
Posted on Apr 20, 2010
SOURCE: code p0455 evap emission (large)
have the gas cap tested or just replace it, then disconnect the battery for 5 minutes to reset the code, then drive it for a few miles and see if problem comes back, if it does a trip to the dealer is in order, as this may be covered by your emission warranty which is good for 70,000 miles.
Posted on May 26, 2009
Tips for a great answer:
Mar 07, 2018 | Cars & Trucks
Sep 19, 2016 | Cars & Trucks
Jun 26, 2015 | 2006 Chrysler 300 Touring
Jul 01, 2014 | 2002 Jeep Wrangler
Nov 23, 2017 | Chevrolet Impala Cars & Trucks
Aug 24, 2011 | 2002 Jeep Grand Cherokee
Nov 23, 2010 | 2000 Jeep Cherokee
Nov 14, 2009 | 2003 Chrysler Town & Country
Oct 06, 2009 | 2001 Hyundai Elantra
Aug 14, 2008 | 1999 Jeep Wrangler
6,715 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: