Abs sensors are usually placed behind the hub common up the axis of the hub side facing forward or bridges carrying the transport direction of the shaft.
If a wheel is out from under the car for the principle to be there 1-2 power cord is usually one of the brake wear sensor wire but the other usual abs-conductor wire ends as soon as it is usually the sensor. Do not break wiring in vain. Abs sensor wire is usually a well-insulated connector. Beware off the assembly, abs sensor Latching bolt or screw may not be so easy anymore to come off it can break (corrosion have done their job). And as the abs sensor in taking her out of the socket - they are often stuck as a result of corrosion. Beware of the assembly, so as not to damage the abs ring gear.
SOURCE: Torque setting for peugeot 206
hallo
If you have normal 1.6 liter 206:
max bolt lenght:176,5mm
20Nm and aditional 240°
1,6 liter 16valve engine
max bolt lenght:122,6mm
20Nm and aditional 260°
Marko
SOURCE: I can't found fuel filter on my peugeot 206 1.4 lx 2002
if its diesel 2000 hdi .........its under the hdi cover under the bonnet
if its a 1400 hdi.........
its to the right of the air filter at the back of the engine
SOURCE: Rear clunk in Peugeot 206, 2002
you may have a problem with a sticking handbrake
usually what happens is one of the brake shoe linings comes off and gets stuck when the car is stopping
the noise your hearing in the brake releasing
SOURCE: how to turn off the airbag on peugeot 206 1.6
there should be a key switch inside the car somewhere you need to turn it to the off position with the ignition key
(it will probably be some where on the dash, in the glove box or center console)
308 views
Usually answered in minutes!
×