20 Most Recent 2001 Peugeot 206 1.6 Questions & Answers

I would say it's a bad ABS sensor. That's where I'd start looking.

try this:

You use: - "1" key to enter first digit of code (i.e. if first code digit is 5 you have to push "1" until it shows 5 on your display) - "2" key to enter second digit of code - "3" key to enter third digit of code - "4" key to enter fourth digit of code - "6" key to confirm code

no it is the ignition module

Limp Mode is usually a transmission failure that will have to be diagnosed-check for codes & google what they are There are overheating & possibly other limp modes on some vehicles Can't use it at all like that & not cause a problem Need a repair shop or dealer

It's for brake fault pads, sensors low fluid

The ABS light normally illuminates to indicate that the ABS module is out of parameter, which may indicate a POTENTIALLY DANGEROUS CONDITION. Usually, replacing the ABS module will cure the condition, and the ABS warning light will turn off.

check the engine mounts and reaction rod bushes. check suspension rubbers

disconnect all (2) power wires.and connect again see it out.

Reach from under the car after exhaust pipe is removed from manifold.

I can say we would not have any code info here at fixya. Sorry.