I would like to know, I have a 1998 Toyota Camry drums in the back I would like to switch to disc in the back.

Noise after replacing rear brake shoes and drums...help! - Toyota ...

www.toyotanation.com/.../328271-noise-after-replacing-rear-brake-shoe...
Jan 19, 2010 - 15 posts - ‎9 authors Check to make sure the new drums dont have a longer/thicker drum face that is scraping the back plate. ... 1998 Mazda 626 FS-DE/CD4-E .... I experienced rear shoebrake clicking/clacking with an older Saturn. ... plate and to be banged back against the plate causing the clicking or clacking noise. screeching noise from rotors + brakepads after ...
15 posts
Nov 20, 2009
'95 Right Rear Brakes makin' a "clicking" noise when ...
15 posts
Jan 6, 2008
Rear Brake Noise
15 posts
Oct 30, 2005
More results from www.toyotanation.com

See here for details, p37 or p44 depending on the car

http://www.turboninjas.com/camry/br.pdf


As to special tools, a can of brake cleaner spray (must be meant for brake parts), a pair of big strong pliers, a wire brush, and a set of metric spanners.

Are they disc brakes? Front or back?

they use the disc brake system for normal braking. the little drum system is soley for the parking brake. european in design and works very well.

The scheduled maintenance to be performed are listed below:

1. Replace engine oil and oil filter
2. Additional Maintenance Items for Special Operating Conditions:
3. Driving on Rough, Muddy or Snow-Melted Roads
4. Inspect ball joints and dust covers
5. Inspect brake linings/drums and brake pads/discs
6. Inspect drive shaft boots
7. Inspect nuts and bolts on chassis and body
8. Inspect steering linkage and boots
9. Rotate tires
10. Driving on Unpaved or Dusty Roads
11. Inspect brake linings/drums and brake pads/discs
12. Inspect engine air filter
13. Extensive Idling or Low-Speed Driving for Long Distances
14. Inspect brake linings/drums and brake pads/discs
15. Towing a Trailer or Using a Camper or Car-Top Carrier Inspect brake linings/drums and brake pads/discs
16. Inspect nuts and bolts on chassis and body.

Just make sure the timing belt is on properlyy, lining up the cam and crank in proper position to each other. The engine willstart when fully assembled because the electrical has not be altered. If it has a crank position sensor , be sure to put it back on after cleaning it and the connector.

Click on the following free direct Link. It has the Timing: Belt and Mark Diagrams for your 1998 Toyota Camry. Plus additional Instructional and Directional Diagrams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1998/make/toyota/model/camry/1998_toyota_camry_timing_belt_diagram_marks.htm

cant get to the back spark plugs on a 1998 v6 toyota camry

Easy. Take wheel and tire off, and remove the brake drum, if it has drum brakes. With a hammer, hit the broken stud until it pops out. Slide the new stud into the hole, and, using some thick washers, screw the lugnut onto the new stud, over the washers. Tighten it until the stud is pulled all of the way in. Easier done with an air wrench, however.

Its A Rear Tire Id Guess Its Gotta Be A Problem With The Brakes And Not The Brake Pad. I Would Recommend Taking It To A Mechanic If Thats Not An Option Get The Book. Jack Up The Vehicle And Remove The Suspicious Tire. Mark One Spot On The Drum And One Spot On The Center Hub. Then Check The Inside Of The Drum Once Removed And Inspect it Also Check Your Brake Pads. Not Many People Know That Drum Pads Release Outward Instead Of Inward Like Disc Brakes. Hopefully This Will Help You