Replaced fuel filter,hear the fuel piump humming when the key is in the on position
You must be getting fuel, remove fuel line @ engine, have someone crank the engine, then you'll know, NO SMOKING ! if no fuel, check fuel pump relay ! check all fuses . pump should hum for only 2 seconds, when key is turned to ON position. to prime the system. always check all ground wires to fuel system. important ! good luck
SOURCE: 1999 chevy blazer wont start
THE FUEL PUMP IS BAD.
if your losing fuel pressure after the pump runs the drain back valve in the pump has failed.
and i doubt that you are seeing enough fuel pressure to run a vortec engine.
low fuel pressure equals a non running vortec
SOURCE: 2001 chevy blazer replaced fuel pump, wants to
hi its rob was it running befor u replaced the pump if its petrol take out the spark plugs maken sure not to mess up the timeing give them a clean .if its deizil prime the system o open the injectors
SOURCE: my 2001 chevy silverado has no fuel pressure when
Try having the fuel pressure regulator checked, it's round in shape at the end of the fuel rail, and has a small vaccum line connected to it.
Also check that vaccum line to see what shape it's in, the littlest pin hole will cause a problem.
SOURCE: 2001 chevy blazer turns over but wont run. new
Try to do the crank relearn:
Ensure that your battery is fully charged before attempting the relearn procedure. Do not leave any battery charger or jumper cables attached to the battery. Close the hood completely. Some applications require that the doors remain closed during the procedure.
96-99 S10
1. Rotate the key to the start position to attempt to start the vehicle (the vehicle will not start).
Allow the key to return to the all position (same as if the vehicle would have started). The theft system light will flash (or stay lit) on the dash for approximately 10 minutes.
2. When the theft system telltale stops flashing (or turns oft) turn the key to the off position for 5 seconds and then attempt tostart the vehicle. The vehicle should start on this cycle.
3. Once the vehicle is running, the password relearn is complete.
00 + S10
1. Rotate the key to the start position to attempt to start the vehicle (the vehicle will not start). Allow the key to return to the on position. (same as if the vehicle would have started)
2. The theft system light will flash (or stay lit) on the dash for approximately 10 minutes.
3. When the theft system telltale stops flashing (or turns off) turn the key to the off position for 5 seconds and then attempt to start the vehicle.
4. Repeat steps 1 through 3 two more times for a total of 3 cycles/30 minutes.
5. On the next cycle of turning the ignition key from off to crank the vehicle should start
6. Once the vehicle is running, the password is learned and this completes the cycle.
7. Clear any DTC's with a scan tool if necessary. DTC history will be cleared after 100 ignition cycles.
Thank you for using fixya and keep me posted, be glad to help you get your jimmy running 100%
371 views
Usually answered in minutes!
×