I bought a 98 Jeep Wrangler from Marietta Jeep and they had installed an alarm that uses a small key you plug into a receiver under the steering wheel. It worked for 10 years but now it won't disengage. When I try to start the Jeep the horn honks and lights flash, but won't start. Any ideas how to disable the alarm?
Your vehicle has 2 ignition wires that you can put back to factory, and start the vehicle.
The wires you are looking to put back together are (blue) and (black/orange) - and found under the D/S dash. (ignition harness) They will be larger in Diameter than the others.
They were cut to install the security system. They go into the "brain" and out the other side. A relay inside the BRAIN is most likely failing.
If you no longer want the alarm installed, simply match up all of the factory colors. Use crimp-on ****-connectors for secure connection.
Let me know if you need more help.
352 views
Usually answered in minutes!
The fix was dead on. The only changes is they did not splice the Orange wire. All I had to do was connect the large black cable to itself and everything works fine now. Thanks for your help.
×