SOURCE: replacing oil pan on 2003 dodge neon
To replace the oil pan jack and place car in towers. Remove the undercover shielding and watch out for the exhaust that will also have to be move. Drain the oil pan. The holding bolts will be removed with appropriated tools. Tap with wood block to lose it. Once removed check the oil pump for damage. To replace make sure to used a proper gasket and sealant. Install all parts back.
SOURCE: location of oil sending unit
its on the rear of the block, driver side, about halfway up --- behind and practically entangled with the harness.
A better question: How do you remove the connector?
SOURCE: oil pressure sending unit location
oil pressure sending unit show location on 2000 dodge caravan V-6
SOURCE: need to replace oil pressure sensor/or sending
In my experience with neon's the sending unit is most likely not the problem. I feel that you will find that the oil pressure is actually low and that the oil pump is going out. If you change the sending unit and it doesn't change then you will know for sure. The sending unit is located on the side of the block near the oil filter. It has one wire and simply unscrews and the new one screws back in and re-attach the wire. Hope this helps. Good luck.
1,667 views
Usually answered in minutes!
×