How to replace windshield molding
SOURCE: 97 Jeep Cherokee Sport Windshield Washer Pump Replacement
Remove the windshield wipers. Pull away from windshield until and use a screwdriver to pry clip on bottom of wiper arm and remove entire arm from mount. Now remove shroud that is under wiper arms you just replaced. After you move the shroud, you should be able to get at the pump.
SOURCE: 2000 Jeep Cherokee Windshield Washer
You have a motor for the front and rear washer. Check the fuses. If the intermitted wipers does not work, there is a relay under the dash near the steering colum that needs to be replaced.
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: how to dismantle rear windshield washer pump for
If I remember correctly, pump is in the same bottle as front unit. Makes sense, otherwise you'd have two bottles!
SOURCE: Replacing water pump on 2000 Jeep Grand Cherokee V6
i have a 2000 grand laredo jeep cherokee that is leaking fliud bad i think it the water pump how do i fix it ??
130 views
Usually answered in minutes!
×