When the shifter cable was installed it seems like it wasn't adjusted correctly when installed,
the person that installed it said that it was.
It normally just bolts right up to the transmission and your shifter, but when you do this you should have your car on jack stands and run through all the gears from the shifter making sure it works and doesn't get stuck, it might look hooked up right but if never ran through gears you don't know how it's adjusted
×
SOURCE: 2005 Dodge RAm 2500....shifter linkage broke
there is a recall for that problem dealer fixes for free
SOURCE: 2003 dodge ram 1500 vibration problem
Check to see if the brakes on the left side are sticking.
SOURCE: 2003 Dodge DSL 2500 transmission shifting problems
sounds like you should start by dropping the pan and changing the filter, put cheap fluid in it or reuse the old fluid if its not too bad bring it to a shop and have a transmission flush performed with a good flush machine your valve body is sticking and this should clear things up please rate -jeff
SOURCE: 99 dodge ram 1500 4x4 5.9l tranny problems
Take a look at the down shift cable and make sure its not broken especially were it connects to the throttle linkage.And maybe try cleaning the electrical plug that plugs into the trans.Its about a 7 to 9 wire plug.They tend to collect water and short the wiring out.
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: 2008 Avenger shifer stuck in park
You need a new shift lever assembly. I see them go bad all the time. Should still be under warranty if it is under 36K.
1,408 views
Usually answered in minutes!
×