2006 kia rio misfire

SOURCE: Check Engine light

that code definition is "Evap high purge flow fault". It means you may have a problem with the evaporative system. this system routes fuel fumes back to the fuel tank. If you want to try and clear this code, find the radio code for your car and then disconnect the battery for 30 seconds. Reconnect the battery and the check engine light should be out. You will then need the radio code to reset your car stereo. the check engine light may stay off if the condition was a transient one. If not, the light will come back on after you drive the car two drive cycles. That is: two starts, warm ups and shut downs. If the light returns, have a mechanic check it out.

SOURCE: Kia Rio Check Engine Light

check the fuel line hose near the fuel regulator for wear as they tend to leak or corrode causing a gas smell inside the car. My 2000 Kia Sportage just had the same problem with the gas smell inside the car.

Marvin

• 85242 Answers
• Posted on Feb 17, 2009

SOURCE: 2002 kia rio rxv check engine light came on again..

the check engine light is not caused by any wrong fluid level or dirty air filter or anything else like that, it is caused by well over 100 faults that can occur in the computer controlled electronic engine and emission controls, u will need to go to a Kragen or Autozone parts store and get a free OBD 2 fault code test to get the code that set your light.

SOURCE: 2006 kia rio check engine light on and code P0455

A code p0455 most likely means one or more of the following has happened:

• A loose or improperly affixed gas cap
• A non-conforming gas cap (i.e. not factory/original brand)
• Other leak or damaged piece in EVAP system

• Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back.
• Otherwise, replace the gas cap, and/or
• Inspect the EVAP system for cuts/holes in tubes/hoses (you may hear a vacuum noise or smell fuel), repair if necessary

SOURCE: 2006 kia rio check engine light on and code P0455

A code p0455 most likely means one or more of the following has happened:

• A loose or improperly affixed gas cap
• A non-conforming gas cap (i.e. not factory/original brand)
• Other leak or damaged piece in EVAP system

• Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back.
• Otherwise, replace the gas cap, and/or
• Inspect the EVAP system for cuts/holes in tubes/hoses (you may hear a vacuum