SOURCE: Replacing the heater core on a '88 Plymouth Sundance?
Behind the dash. You will have to pull the whole dash assembly. It looks like a little radiator.
SOURCE: 1993 plymouth sundance will turn over but will not
Hi I am vortash to check if the cylinders are getting fuel just turn the vehicles engine few times then remove a spark plug to see it it is wet if it is not a fuel problem more likely spark failure replace plugs as they can fail under pressure and check for spark ,, may als be a head gasket problem so check compression and see if above 140 0r in the green with each cylinder . hope this helps regards vortash
SOURCE: 1989 plymouth sundance obd1 code 11 car dies when
The code 11 is referring to your coil pickup.This is located under the distributor cap and rotor,and is held in by the distributor cap itself.Being electrical when it gets hot the sensor brakes down .The pickup is not very expensive at all:)
SOURCE: where is the relay located for the turn signals on
your fuse block is located behind the steering column cover acessible by removing the fuse access panel above the hood latch release lever.the relay and flasher module is located behind an access panel in the glove box.included in the module are hazard and turn signal flashers along with time delay and horn relays.you have additional relays mounted on the inner fender panel near the battery and strut tower.
SOURCE: 1997 plymouth voyager dies without warning when i
This was a common problem mostly with the 3.0 not so much the 3.3 or 3.8. Im not sure what engine you have because they came with both. Im guessing you have the 3.0. The problem I always had was the throttle body would get dirty inside causing not enough air to get into the engine at idle. Remove the air cleaner hose at the engine side then get some carb cleaner and spray it inside the throttle body. Take a clean rag and clean the butterfly and its edges and around the inside where the butterfly closes. This will most likely take care of your problem and it cheap fix if it works.
66 views
Usually answered in minutes!
it needs idled up i never had that until i idled it down there is a screw on the throttle body that holds the thottle open just a little bit tighen it to the right a few times should be fine
×