20 Most Recent 1991 Plymouth Sundance Questions & Answers


mass air flow censor

1991 Plymouth... | Answered on Dec 20, 2017


auto parts store can order rebuild engine or go online look for rebuild engine for 91 plymouth.should find one on internet.

1991 Plymouth... | Answered on Dec 17, 2017


Sounds like one of your pulleys is bad. Alternator, water pump, don't know till you find it. You say you have more than one belt-try taking one off at a time, run engine for a couple of minutes and see if squealing goes away. Maybe you can isolate it that way.
If belts are off, you could spin each pulley by hand to see if you could catch the one that is bad. Any little wobble or play in any of the pulleys would be very suspect as the likely bad one.

1991 Plymouth... | Answered on May 11, 2017


detent cable way out of adjustment

1991 Plymouth... | Answered on Apr 18, 2015


Many auto parts stores will do scans for free to display what the check engine light is on for.

1991 Plymouth... | Answered on Sep 29, 2014


Bearings often will calm down with noise after they get hot. Just because the idler bearings, belt may be new it could still be a bearing in an alternator, AC, power steering, ect.

1991 Plymouth... | Answered on Apr 04, 2014


run fault codes and check for cam/crank position sensor problem/ Check that the camshaft is turning ( broken timing belt/chain) check operation of the immobiliser

1991 Plymouth... | Answered on Mar 18, 2014


The oil pressure light can/will keep power from reaching the fuel pump. So you would need to check oil pressure first.
Then once the oil pressure light problem is resolved checking the fuel pressure might be next.

1991 Plymouth... | Answered on Feb 03, 2014


overheating sound like faulty thermostat.thermostat either sticking close or could have blown headgasket if you see a lot of white smoke coming out of exhaust.if headgasket is leaking check engine oil should look milky.also check water pump look around weep hole or see coolant leaking around water pump replace water pump.also check water pump drive belt.make sure drive belt not loose slipping.

1991 Plymouth... | Answered on Mar 26, 2013


THe clutch is located in the flywheel housing directly behind the engine. Put you foot on the brake while having you foot on the accelerator and at about 1500rpm let out the clutch pedal. If the engine dies immediately the clutch will be good . If the engine continues to rev with the pedal full out you have a clutch problem This test should last maybe 5 seconds.

1991 Plymouth... | Answered on Mar 10, 2013


You change the head gasket

The spitting is cylinder pressure or combustion
gases blowing out coolant

1991 Plymouth... | Answered on Mar 09, 2013


did you try the pick up coil or hall effect,its under the dist cap with a wire coming out to a plug.

1991 Plymouth... | Answered on Mar 01, 2013


Your timing belt could be broken or perhaps the Drive chain that drives the two balance shafts behind the timing belt

1991 Plymouth... | Answered on Feb 14, 2013

Not finding what you are looking for?
1991 Plymouth Sundance Logo

97 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Plymouth Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sundance Plymouth

  • Sundance Plymouth

Most Popular Question

trouble shoot check engine light

  • Cars & Trucks
Loading...