Trying to install a Fram CF 9846A Air Filter
It is behind the glove compartment. It has to be removed.
This is from Ehow.com - - 4. Pull the glove compartment out of the dash. Disconnect the light wire once the glove compartment is about halfway out. 5 Press the tabs on both sides of the cabin filter cover towards the middle of the filter compartment to unhook them. Remove the cabin filter cover. 6 Slide the old filter out of the filter housing. Read more: How to Change the Cabin Filter on a Mitsubishi Endeavor | eHow.com
×
SOURCE: trying to change the cabin air filter
1. Open glove box
2. Unhook elastic retainer on right side
3. Locate the two "stop tabs", one on the upper left and the other on the right side. Push both to the left to clear their stops and the glove box will swing down, allowing access to the filter cover.
SOURCE: cabin filter element location
Filter is located behind the glove box. All you need is a screwdriver to replace.
1. Open the glove box and empty to take the weight off the box.
2. On the right side there is a plastic hinge like device held on by one Phillips head screw. If you have trouble removing with a Phillips screwdriver you can remove with a narrow flat head screwdriver. Remove the screw and slide hinge off the mount.
3. To drop the glove box press the sides slightly inwards while 'forcing' it open beyond it's normal stopping point. Careful as when it releases it will fall wide open and may even fall from its hinged area. Set it aside.
4. Behind the glove box there is probably some fiberous material inserted to prevent noise like squeaking when it rubs. It is sticky on one side to hold it in place. Just remove and place out of the way.
5. Behind the fiberous material there'll be a cover which kinda looks like a grille. Mine was white and it is in the center of the opening. Remove it by releasing the clips at the left or right. It comes right out.
6. When the cover comes off slide the filter out and replace it. The filter lays flat and just slides in and out easily. However, if it has been some time since you replaced be prepared for a lot of debris on top of the filter such as leaves, grass or other general type of debris that has been sucked into the filter. It also may be the source of any bad odors that you smell through the air conditioning system.
7. Reverse the process. Replace the cover and push the glove box lid back into place. When you replace the glove box be careful to make sure the hinge you initiallly removed the screw from is not left behind the glove box or you will have to remove again to get it out. Replace the screw and do not over tighten as it screws into plastic and then your done.
SOURCE: Cabin air filter location 2003 F250 6.0L crew cab pickup
hey jack open the back door and look up top where the hinges are and that should be the one for the back and the front if it is not up under the hood where the wipers are then check up under the dash
SOURCE: Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)
IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE
SOURCE: cabin air filter, location
It's located on the engine compartment firewall, passenger-side. Open
the hood, stand by the right front wheel and you'll see the fasteners
to remove forward of the wipers. Fasteners are removed by pushing the
center in, then pulling them out. To replace. pull the center out,
replace it, then push it flush to lock.
Good luck and hope this helps.
188 views
Usually answered in minutes!
I took out the glove box and removed the plastic noise barrier. I still do not see where this Cabin Fliter can go. I know some 2005 Endevors and earlier models did not come with a cabin filter but this a 2006 and everywhere sells the filters soIm just confused why I cant locate it. More help please. I will try to add a picture as well.
I added the picture as my profile pict since I do not see where to upload one on here. :)
×