2008 pontiac solstice driver sider door handle

Walter Whitaker

• 25 Answers
• Posted on Dec 06, 2008

SOURCE: Door Panel removal

remove all visable screws from panel and arm rest. Arm rest should come off. Use a flat thin tool or piece of metal and slip it between the panel and the metal door frame. Slip it in about 2 inches,. Slide it back or forth til you hit a stop. That should be a plastic pop in.twist metal tool to pull panel away from the door. It should pop away from door frame. Don't overdo it if it doesn't come out. try another spot. once you get one loose, you can tell how to get the others out. Once panel is loose push it upwards to get top lip out of window bottom. If it has power windows,disconnect plug. If it has manual windows, you will have to remove the window crank There is a snap ring behind window crank that has to be removed.push in on panel by window crank and you can see the ring.

Anand Kumar

• 2035 Answers
• Posted on Jan 26, 2009

SOURCE: broken exterior door handle,passenger sider ,sliding

Front

1. Close the front door glass completely.
2. Disconnect the negative battery cable.
3. Remove the door screen.
4. Disconnect the front door lock actuator connector.
5. Disconnect the rods and the cables.
6. Remove the screws, and remove the front door lock.
7. Remove the screws, and remove the front door lock actuator from the front door lock.
8. To install, reverse removal procedure.

1. Close the front door glass completely.
2. Disconnect the negative battery cable.
3. Remove the door screen.
4. Disconnect the sliding door lock actuator connector.
5. Disconnect the rods and the cables.
6. Remove the bolts, and remove the sliding door remote controller.
7. Remove the screws, and remove the sliding door lock actuator from the sliding door remote controller.
8. To install, reverse removal procedure.

SOURCE: driver door handle will not open door 1993 Honda Civic

there is a pin in the door handle might have broke off there are two 10 mm nuts that will release the handle but you have to take the door panels off and remove it any local junk yard should have it or can order it for you

SOURCE: How to install a pontiac G6 driver door handle

Yeah, you have to remove the lock. Use an impact drill with the right phillips head to remove the screws. if you try to take them out with a screw driver, you will strip them. Remember...impact drill.

SOURCE: BMW X5 2001 -DRIVER OUTSIDE DOOR HANDLE WILL NOT OPEN DOOR.

DRIVER OUTSIDE DOOR HANDLE WILL NOT OPEN DOOR. FROZE UP IN ICE STORM AND APPEARED TO BREAK WHEN TRIED TO OPEN DOOR. INSIDE HANDLE STILL WORKS. IS DIY REPAIR FEASIBLE?