20 Most Recent 1999 Oldsmobile Aurora Questions & Answers

No way to do this, the alternator is not made/engineered to use an off alternator external voltage regulator. Why would you need to do this?

Purchase 1 more can and allow it enough time to fully get into the system. You can have the car running while this is happening so it warms the can allowing it to charge faster. Let me know.

one and the same

Non working turn signals will not drain the battery because they work when the key is on. You may have a bad battery. If your signal lights come on and do not flash, you have a bad flasher which should be located under the dash area. As for the battery, most parts houses will check the condition of the new battery for free. If you think you have a bad battery, make sure that it has a good charge then disconnect it from the system by disconnection one of the cables. If the battery goes dead overnight then it is self draining.

this should be the one.

Both switches are simple on/off, so you can test with an ohmmeter or just bypass with a paper clip. See your diagram at the link below. http://www.revbase.com/BBBMotor/Wd/DownloadPdf?id=17528

It's on the right front corner of the engine comp. Then there is the one under the rear seat and the one on the drivers on the bottom of the door pillar (a-pillar).

Hope that helps

Your master switch is stuck in the running position and need to be replaced. Very simple to do. The reason your battery is running down is the switch is constantly activated and draining the system. Once you replace the switch everything will be good

These cars were designed to have daytime running lights, that can turn off with the ebrake being pulled, so perhaps whatever wiring mechanism that enable that, is failing.

Squeeze or slide the cover off . And the bulb will be attached at both ends , just grab at the center and pull it toward you !

It maybe tripped already , inspect the catch !

Alarm maybe set !

If there 8MM bolts then the torque is 16FT.LBS if there 6 MM bolts then the torque is 8.5 FT.LBS

will need to remove door panel to inspect the lock rods ,clips and actuator ,,what usually happens is one of the lock rods either pops out of clip or clip breaks