Nissan versa 2007 sometimes will not crank just keeps trying after about25 timemotor spins ok,after cranks has strang smell ,will not happen again for awhile.
Sounds like your starter cylinoid is sticking needs to be taken off and tested and maybe rebuilt or replaced
SOURCE: long crank time before starts
Thoroughly clean interior of throttle body especially area where butterfly flap seats and all drillings, use aerosol carb cleaner, check air filter and spark plugs (platinum type only!). Then set idle with a consult unit or similar, engine management must be in service mode to set idle properly.
Also test coolant temp sensor it may be open circuit. If you don't know how to do this ask me.
Forget about earth if starter turns engine over at normal speed.
SOURCE: 2001 nissan maxima gle crank no start code p1320...please help
Primary ignition fault. Reasons: Bad distributor cap (most likely) or ignition control module/ignition coil.
Hope that helps
Good Luck
SOURCE: Unusual starting problem, Nissan sentra '96 GXE 179K
ha there i think you a mager wireing prolbem or your ECM computer is short.
SOURCE: 300ZX wont start, or crank for nothing
The car seems to have functioning parts but it is probably a wiring issue - have you done a heater core replacement or anything under the dash/hood in a while (other than "tapping on the starter" <-- which you shouldnt do by the way)
what year is it??
if it is a 1990 the car has a plug undone under the driver side steering column on the "security" and "ignition" wiring circuit - read your FSM (factory service manual) and diagnose the problem. it is definately a short somewhere!
381 views
Usually answered in minutes!
×