I need a diagram to find the coolant temputare sensor for a 2002 ford focus zetec

Pin 1 - Signal (Green/Yellow) Pin 2 - Signal Return (Grey/Red) Pin 3 - Signal (Orange/Red) Pin 4 - +5V Reference (Orange/Yellow) Pin 5 - Ground (Black) Pin 6 - Not Used

If you Blew off the timing belt then need Head work also since it is an interference Motor
meaning that the Valve train and Pistons Have no Clearance so U are going to need a lot more work than just a timing belt to run

i have ford focus ghia 2.0 2002 model and i have problem with the fuel pump sometimes it works sometimes it doesn't.. when i fill the tank petrol pores out, the pipe next to the filter also comes out, how do i fix the problem?

good afternoon, I want to change the ford focus band 2001 zertec2.0 has a / c and I want to eliminate it,
the bamda should be ordered is for car without a / c or would take another measure
Thank you

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V

1 - a tank of the hydraulic booster of a steering; 2 - a plug mouth oil-jellied; 3 - a tank of a working liquid of a braking system and clutch; 4 - the assembly block of safety locks and the relay; 5 - an air filter; 6 - a windshield washer reservoir; 7 - the accumulator battery; 8 - the identification tablet; 9 - a measuring instrument of level of oil; 10 - an expansion chamber of system of cooling.

Ford Focus engine diagram Ford Focus engine diagram - turbo-diesel of 1,8 l Endura-DI Ford Focus engine diagram - turbo-diesel of 1,8 l Endura-DI

1 - a tank of the hydraulic booster of a steering; 2 - a plug mouth oil-jellied; 3 - a tank of a working liquid of a braking system and clutch; 4 - the assembly block of safety locks and the relay; 5 - an air filter; 6 - a windshield washer reservoir; 7 - the accumulator battery; 8 - the identification tablet; 9 - a measuring instrument of level of oil; 10 - an expansion chamber of system of cooling.

I have the U S wiring book. It may be similar to European version. I will look at work and see. Does the cooling fan come on when you turn on the a/c and the compressor clutch? The fan should cycle with the a/c clutch. Also, do you have 12 volts at the motor connection when the car is hot? There should be a big fuse in the box under the hood and probably a relay.
ALso, the ECT, engine coolant temp sensor on the engine should also tell the computer to turn on the fan when the coolant hits a certain temp.

I had same problem. located above/behind the Right Front Tire. I didn't believe it either.

Here ya go.

plese rate

what engine?

2.0L SPI w/o a/c

2.0L SPI w/ a/c

2.0L ZETEC

ZETEC W/O A/C

its screwed into the cylinder head ,when you fit a new 1 dont overtighten it they sense temp of the head they dont screw into the water jacket!!!!!!!!!!!!!!!!!!!!