I removed the passenger sweat and disconnected the wires. When I reinstalled the seat and reconnected the wires, the seatbelt light is flashing in the dash.
A scan tool is needed to reset the seatbelt light, unhooking the wires turned the light on as a fault, a scan tool will reset code. also make sure all connectors are connected good, the computer may reset itself after it sees a few key cycles and tests the system and it passes but it may take awhile. i have seen some that will stay on until they are reset, if the light is still on after all this time then a scan tool will be needed to turn off the light. good day.
My seat belt light is staying on what can I do
SOURCE: 1994 Nissan Altima Passenger Door won't open
Since you have the door panel off, pul the rod for the door lock manually inside the door, this should unlock it, if it does not, there is a small push button, basicly a little peice of metal on the latch itself on the door latch inside the door, push it down this should pop the door open, you may need to spray all of the mechinisms with white lithium grease in a arosol can.....
SOURCE: 2004 Nissan Altima passenger side low beam
I would look at the fuses also. these newer cars have seperate fuses for driver an passenger headlights.
SOURCE: How do I change the passenger side headlight bulb on 2001 Altima
Open up the hood, and go in behind the fixture where the light is located. Sometimes there is an access panel on top. Open it and reach down inside and grab the bulb’s socket. Twist the socket a quarter turn counter clockwise, and pull out the socket. Grab the bulb, and pull it straight out. To replace the new bulb, never touch it with your bare fingers, as this will greatly shorten the bulb's life, if it even work's at all. Use a tissue or something else in that order to handle the new bulb. Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fix.Seems that you have to remove the coolant bottle(two screws), and also the unscrew the washer fluid bottle, after that you can reach the socket that holds the bulb. There is a wire that holds the bulb in. if you loosen the screw you can tip up the wire and be careful to leave it in place...also the long side of the wire seems to connect to ground wire for the light...
SOURCE: 2000 nissan altima: driver side seatbelt is in
Take the bolt out of the top of the seat belt and release the pressure on it.If this doesnt work the safety module will have to be replaced.
SOURCE: 2001 Nissan Altima front power seat does not move
needs a forward/rearward motor. it has two separate motors under the seat. very common and i replace them all the time. good luck
2,860 views
Usually answered in minutes!
×