20 Most Recent
2003 Mitsubishi Montero Sport - Page 2 Questions & Answers
Location of oil drain plug on 2003 montero sport
You will have to get under the vehicle and find the oil pan directly under the engine. On the oil pan you will locate the bolt to drain the oil pan. They usually are at the lowest point on the oil pan so that all the oil is drained from the pan when removed.
Changing Front Rotors
I'm at the exact same spot.... if anyone can throw us a bone on this I would greatly appreciate it!
2003 Montero Sport 3.0L, 135K miles. Cold start, idle ok. Once warm, low idle and sounds like it has a miss.
Your going to need a wiring diagram. You have a MAF,MAP, IAT and EGR sensor problem. My guess would be a signal wire or ground is bad. These four sensors are right at the throttle body. The mass air flow sensor and the manifold absolute pressure sensor are one in the same. The intake air sensor is next to it. All are located in the air induction plenum. Between the throttle body and the air filter. The Engine gas recirculation valve/sensor is right behind the throttle body. So check the harness from the air filter/ MAF to the engine harness plug. Look for conduit that is rotted away and/or melted.
The alternator on my 2003
Check to see if there is wiring faults along the path to the alternator to the battery. It may be receiving a power surge. Check the wiring.
Why is it buzzing by my tranny pan when i put it in gear?
needs service.
get it service fast, or it can get worse.
ever price a new tranny?
check level first, dont guess, use the instruction on how to do that.
its not like the engine oil level checks at all , read the method
do not overfill it.
ATF levels check is in most operators guide, if missing that means
its FSM covered.
factory shop manual
Engine Service Soon Light On code P0154
Error Code: P0154
Description:
Heated Oxygen Sensor (HO2S) 1 , Bank 2 - No Activity Detected
Problem areas:
- Wiring.
- Open circuit in signal wire, between Heated Oxygen sensor 1, Bank 2 and ECM. (Must check and confirm)
- Heated oxygen sensor (HO2S).
- Engine control module (ECM).
No heat
- Check the heater pipes routing.
- Heater radiator.
- Heat control valve.
- Control panel.
Not finding what you are looking for?