20 Most Recent 2001 Nissan Altima - Page 8 Questions & Answers

Its plugged into the bottom of the radiator. there r 2 hoses going 2 the radiator. that's it. unclamp and remove to do flush.

where is the overload protection circuit for power seat of nissan altima 2001 , the seat does not move back and front let me know if i could do the seat move

If you are talking about the evaporator for the ac, the component would need to be replaced.

SOUND LIKE PROBLEM IN THE FUEL SYSTEM.COULD HAVE STOPPED UP FUEL FILTER.FUEL SYSTEM TOO LEAN.

no you dont need to remove engine. but you have to engine hoist or chain hoist support engine because you have to remove front engine mount to remove timing chain cover.

Did you prime the pump before you started the engine ?

Hi Amanda,are you talking about the brake bleeder screw,here's a link to your brake caliber,as you can see,the bleeder screw is on front,and your back brakes are brake shoes and on the inside,you will see the bleeder screw at top.its the wheel cylinder.Here's the rear wheel cylinder,all you will see is the bleeder screw coming through at the top plate,will have to crawl under and look at the top part,you can get a bleeder kit at autozone,here's what it says about bleeding your car.

sounds like a bad ground on ground ternmal on trans the cable smokes from high resistance unless your starter shorted

Open the hood and look for the clutch master cylinder. It is smaller than the brake master cylinder, but should be very near it.The clutch master cylinder is about half the size of the brake master cylinder. Take the lid off and see if it is full.If it is empty, the likely problem is the slave cylinder (which is mounted on the transmission at the other end of the brake fluid line), has failed and needs to be replaced. It will likely not do any good to fill the clutch master cylinder, as you will trap air in the line.The slave cylinder will need to be replaced, and the line bled to get the air out. Be blessed.

Oil pump is in the oil pan. Usually on the very bottom of the motor. Remove oil pan and you should have full access to oil pump.