20 Most Recent 1995 Nissan Altima Questions & Answers

It could be a bad ignition switch, do you have instrument panel warning lights when you try to start it?

They may be right. I cannot find the part. here is what the manual says:

REMOVAL & INSTALLATION The camshaft position sensor is located inside the distributor. On some distributors, the camshaft position sensor is not serviceable (replacement parts may not be available separately). If the camshaft position sensor is serviceable, use the following procedure.

1. Remove the distributor cap and wires.
2. Remove the rotor.
3. Remove the camshaft position sensor cap.
4. Remove the camshaft position sensor mounting screws.
5. Carefully remove the camshaft position sensor.

To install:

1. Position the camshaft position sensor in the distributor and tighten the mounting screws securely.
2. Install the camshaft position sensor cap.
3. Install the rotor.
4. Install the distributor cap and wires.

Get a quality diagnostic scanner on it to narrow this issue down. Sounds like an ignition module, cps, fuel pump, etc. Seriously, have it scanned for codes!

I think you should go for manual first after that it will be easy for u to solve your problem. I had visited this site past 2 months before for my Car and find it quite helpful may be you will also get something useful here 1995 Nissan Altima

Possibly bad compressor, worn bearings in a pulley or lines TO compressor. Also, perhaps wrong refrigerant added. Sometimes it makes a difference as there are some 7 different kinds.

May be the water pump,

Is this what you have? Does the locking ring screw on or does it snap? Do you see a tab or anything that might have broken off? Can you compare locking rings from one side to the other? Or maybe try a locking ring from the other side for testing? My biggest problem is I can't see anything from here.

Clean the MAF (mass air flow sensor.)Follow the hose from the air filter to the air flow sensor.Use a proper cleaner rated safe for this purpose.

Replace the battery in your key ring.

There's a YouTube video at the link below showing replacement of the water pump and thermostat. It's lengthy, but at 29:40 and 30:18, it shows the cover bolted to the block. It should give you a pretty good idea of the orientation of the cover and the water pump. According to information I found elsewhere, 1993-2001 is all the same. 1999 Nissan Altima Replacing The Water Pump And Thermostat

Is it manual or automatic?

Hi Maricella,I am going to send you some links on your front end from Autozone's repair guide,in order to use all of them like me,you have to join and become a member,it's free,love that word,they just want your email address,a very awesome site,so follow links to some repair guides for your front end,if you have any questions,just ask me. I have alot of other links to other sites for repairing your ride. Repair Guides Front Suspension Sway stabilizer Bar AutoZone com Here's another link. Repair Guides Front Suspension Front Suspension AutoZone com And one more,join now... Repair Guides Front Suspension Front Hub And Knuckle AutoZone com

Tighten up the gas cap.Since it came on right after you put gas in your car this is most likely what it is.After a number of cycles of the key the light should go out on its own.(Don't remember the number of times you have to cycle the key)