20 Most Recent 1999 Nissan Altima - Page 8 Questions & Answers

I am sorry but fixya has no wiring diagrams of any kind. You can obtain the factory diagrams for a small fee at this site www.alldatadiy.com

The engine in the car is fully electronically controlled by a computer referred to as the PCM, when a fault like this occurs the PCM will sense that fault and record a fault code for the system of the engine control that has the problems. What must be done now is to have the PCM scanned for fault codes and then based on that info a trained tech will perform the proper diagnostics to discover the problem part or writing.

Did you change the leads?

check fuseable link near battery if it's blown would pay to look for short circuit before doing much more

Dear Sir:1) Reset the ignition timing to the manufacturer specifications.2) Tes the primary circuit and secondary circuit from ignition system. see the diagram attached. God bless you

This bushing is a pain to install, i have done many of these and end up messing them up before i get one on, to tell you the truth it does not last.I have tried to save customers money by installing the bushing and it comes back to bite me, they get mad because the wiper linkage fell off again in the rain, the sad part was that they were advised that the fix may not hold but they agreed to it to save money, i then found out that the linkage arm could be replaced , it only costs 12.00.there are many auto part stores that sell it even the dealer, Dorman is one company, you can google it.The way i get these bushings on it by applying a little grease around bushing and then with two sockets and a vise, i then press bushing into arm. good day hope this is helpful.

there not that high and there are easy u just got to bleed them when u replace it it will take about 1-2 hours not long at all.

EVAP codes ,gas cap ok?Vacuum leak? Charcoal canister unplugged?

the brake fluid reservoir is on the drivers side of the engine back by the firewall. I believe the cap is yellow and should say brake fluid or DOT3 or something simular. Use only DOT3 or DOT4 brake fluid from a sealed container. You can also consult your owners manual to find it. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa