20 Most Recent 2006 Nissan Murano Questions & Answers

If your 2006 Murano won't start because of a problem with the key fob, you may be able to start it using the mechanical key that is hidden inside the key fob. To use the mechanical key, follow these steps:

1. Locate the small release button on the back of the key fob and slide it to the side.
2. Use the key to open the driver's door.
3. Insert the key into the ignition and turn it to the "ON" position.
4. Press the brake pedal and then push the ignition switch to start the engine.

Interference

Should be in your manual https://www.manualslib.com/

https://www.yourmechanic.com/article/p0340-obd-ii-trouble-code-camshaft-position-sensor-circuit-malfunction-by-jamahl-walker

Did you replace the sensor you're? Was the code erase?

This could be the adjuster screw. Park you car close enough to a wall or any other reflective surface and "mark where the beam is hitting the surface, then try turning the screw and gauge which direction the light beam moves. Adjust it to suit.

looks like the ballast has gone if it blows the fuse, or there is a short in the wring, remove the plug to the ballast and try fuse again if it does not blow when on then its the ballast. if the seal on the unit is damaged in any way water can damage the inside.

If your car has 2 fans one should come on when you turn the A/C on, it should have Relay associated with each fan. The other fan will come on when engine reaches operating temperature. If the Freon pressure is low the low pressure switch could be taking it out.( Not likely but it happened to me with a Cobalt once. This may seem odd but if your alternator is putting out correct voltage, the computer could try to conserve power and be shutting it down. I lost A/C and steering assist and interior lights.) The compressor/clutch could be going bad. Belt may not be adjusted right but normally you will hear it.

You will need the dealer on this, sorry but there is substantial testing needed to correct this malfunction, this testing requires special tools that only the dealer will have..

Certain brands of remote starters come with a switch that is designed to temporarily disable the remote starter. The switch may be under your dash on the driver's side, or in a fusebox. It is NOT designed to be easily accessible. Many times it gets bumped accidentally, and all you have to do is switch it back on. Could the mechanics have accidently hit it

The system is computer controlled and you need to run the diagnostics with a scan tool to see what shows up.

Did you add Lucas no slip?

Hi, Google found this: "To reset the maintenance interval, select the Reset and push the ENTER button. Next, press the BACK button and select REMINDER 2 to reset the tire rotation. select theReset and push the ENTER button. Turn the ignition off and then start the engine to verify the indicator has been reset." and here's a YouTube: https://www.youtube.com/watch?v=K3KjMfuGp5c