20 Most Recent 2006 Nissan Z - Page 2 Questions & Answers

YEs but if you are going to do some secrifice on your luck of car model from front,

otherwise its impossible,

you can get this from older car dealer or service center,

TNX

Question edited to what I think you thought you were typing. Question moved to Nissan. Full wiring diagrams cost money, but you can get partial diagrams free. Google year make model (the part) wiring diagram and look at the images tab. https://www.google.com/search?q=1987+nissan+300zx+wiring+diagram

Hi, This should not be a problem, remember Ethanol was used prior to petrol and the 10% will not cause any rubber failures I used a 50% petrol/Ethanol mixture when racing for 10+ years without any problems. Please leave me feedback thanks, Malcolm Campbell.

Hi, There should be two lines on the dipstick the proper oil level is the higher marking on the dipstick, the lower mark means you need oil putting in the engine. Please leave me feedback thanks, Malcolm Campbell.

Hi, First thing to check is the fuses that may be problem. If the fuse is okay then check for the fuel pump relay fittings. Please leave me feedback thanks, Malcolm Campbell.

Hi, Recommend you buy new set of spark plugs & if that does not fix problem look for new coil. Both items are on the electrics side. For petrol side it may need the fuel pump filter cleaning or renewing, and suggest you clean out your carburetter before spend time on the fuel filter. Please leave me feedback thanks, Malcolm Campbell.

Hi, Recommend you change the stamp seals that should solve problem. Please leave me feedback thanks, Malcolm Campbell.

Hi, Suggest you may have faulty injector or recommend a cylinder pressure test could have broken oil/piston ring failed. Please leave me feedback thanks, Malcolm Campbell.

Hi, you have forgot to state what part you need the torque setting for? only then can anyone answer your question. Please leave me feedback thanks, Malcolm Campbell.

replace the clutch master cylinder

When the check engine light is on, this means the computer has set a fault code which can be read by use of a code scan tool. Most parts stores will read these codes for free, and usually offer advice. Begin with that.

IF the filter is badly blocked up then the safest way is to get a new filter as ant damage to the filter while trying to unblock it will allow items through and will damage what it is supposed to protect.

There may be a hundred of reasons for this issue. Clogged filters, misfiring, fuel quality, faulty fuses... Observe the rev during idling. If it is not steady, this may as well be due to sensors.