2006 Nissan Z - Answered Questions & Fixed issues
The abs light on my
Hi, This means your ABS is not working at all, first check out your fuses before anything else, next bleed the ABS system or even the brakes as this means air has got into the system! Check any leaking brake fluid from pressure hoses. Please leave me feedback thanks, Malcolm Campbell.
9/19/2017 3:25:48 PM •
2006 Nissan Z
•
Answered
on Sep 19, 2017
•
462 views
I have a two door,
Hi, Like you said the rubber/plastic door seals have worn to the extent water is coming into your vehicle. Recommend you take it to any body works shop, they will replace the seals with new should not prove to expensive. Please leave me feedback thanks, Malcolm Campbell.
9/19/2017 2:46:30 PM •
2006 Nissan Z
•
Answered
on Sep 19, 2017
•
190 views
Blower heater unit in micra k12
hi did you get the resistor fixed if not you need to remove the glove box by removing the screws that can be seen then there are two plastic lugs that need to be pulled out sideways to enable you to remove the glove box then you will see the resistor card on the side of the motor thats on the new shape micra k12
8/16/2014 10:10:50 PM •
2006 Nissan Z
•
Answered
on Aug 16, 2014
•
4,831 views
The Abs lights in the Nissan Wingroad is on, how
you need to have faults read. you need a scanner to read codes and any good parts store or shop can scan and tell you what needs to be repaired or what triggered fault. Once fault is fixed they cabn reset lights for you.
1/7/2011 11:50:59 AM •
2006 Nissan Z
•
Answered
on Jan 07, 2011
•
1,253 views
Popping sound in new speaker when i turned it on
trace the wires from this burned out speaker to the stereo, are they actually connected to speaker output or to 12V+
you could have a fried stereo/amplifier or miswired speakers. is one of the wires from the speaker connected to ground? at either end, this could also cook your speakers and amp/stereo...
1/15/2010 6:14:44 PM •
2006 Nissan Z
•
Answered
on Jan 15, 2010
•
180 views
Nissan Almera Tino Right hand side
YEs but if you are going to do some secrifice on your luck of car model from front,
otherwise its impossible,
you can get this from older car dealer or service center,
TNX
5/27/2008 4:50:33 PM •
2006 Nissan Z
•
Answered
on May 27, 2008
•
1,109 views
I am curious about the
Hi, This should not be a problem, remember Ethanol was used prior to petrol and the 10% will not cause any rubber failures I used a 50% petrol/Ethanol mixture when racing for 10+ years without any problems. Please leave me feedback thanks, Malcolm Campbell.
What is the correct level on the markings on the
Hi, There should be two lines on the dipstick the proper oil level is the higher marking on the dipstick, the lower mark means you need oil putting in the engine. Please leave me feedback thanks, Malcolm Campbell.
Not finding what you are looking for?