20 Most Recent
2001 GMC Jimmy - Page 9 Questions & Answers
Shop before you spend
I've learned these vehicles and similar ones have a problem with the back glass hatch NOT releasing... long and short its likely that the little plastic clip broke, Oreilly's sells it alone for $5... so don't by the whole actuator unless you actually need the whole thing!
Rear end is leaking fluid where it connects to the
you mean rear axle pinion seal. to change it you need to remove driveshaft. take a torque wrench to see the running torque. then remove center nut ,remove yoke. with screwdriver remove seal; reverse proc. then tight center nut to torque you find before you remove the center nut.
Where is the jack on
It should be in the cargo floor area, close to the tailgate. Either lift the carpet and/or look for a compartment door. Or is there a panel on the side of the cargo area. The handle to crank the spare up and down, is there too. If you have a space saver spare, its all going to be together under the carpet. Some vehicles place the jack under the back seat.
If you bought it used, a previous owner may have removed the jack. Hope this helps.
The engine light is on
Got get it scanned for free at your local major parts store. Post the code/s for further instructions.
The truck stalled out when driving. Sounds like
code p0410 refers to secondary injection system--malfunction===causes wiring--air valve--air solenoid--- ECMcode p0141 refers to heated oxygen sensor-2 bank1-heater control -circuit malfunction===causes --wiring--oxygen sensor--ECMcode p0128 refers to coolant thermostat --coolant temp below thermostat regulating temperature==causes mechanical fault (thermostat stuck open) code p0102 refers to mass air flow (MAF) sensor/ volume air flow (VAF) sensor low input===causes wiring short to ground--MAF/VAF sensor ECM
Lots of steam and hissing and the temp goes to 260
Your car should not run over 190. As a matter of fact I think you have a 185 degree thermostat. Its very possible that your thermostat is not opening and needs to be replaced. Also check your coolant. Make sure you only used DexCool. Vehicle gets too hot it can blow a head gasket. Warp are crackhead. Or crack your block. So make sure it does not get too hot.
Not finding what you are looking for?