20 Most Recent 2008 Ford F-350 - Page 4 Questions & Answers

Hello,guys. Maybe you could read this article first: How to remove a car's dashboard. Maybe it could give you some help. Good luck.

you need to disconnect the low side line just before the reciever drier and there is atool for pulling it out but you can use small needle noise pliers or a pick hook you need to evacuate the system first to avoid injury

May have to pull the interior door trim off to get to the bolts.

To reset the oil monitoring system to 100% after each oil change
(approximately 7,500 miles [12,000 km] or six months) perform the
following:
1. Press and release the
SELECT/RESET button to display
“OIL LIFE XXX% HOLD RESET =
NEW”.
2. Press and hold the
SELECT/RESET button for two
seconds and release. Oil life is set to
100% and “OIL LIFE SET TO 100%”
is displayed.
Note: To change oil life 100% miles value from 7,500 miles (12,000 km)
or six months to another value, proceed to Step 3.
3. Once “OIL LIFE SET TO XXX%” is displayed, release and press the
SELECT/RESET button to change the oil life start value. Each release
and press will reduce the value by 10%.

check the fuse, it might be blown....Also, check the master brake cylinder. There's a sensor for the cruise control to activate and deactivate. Make sure it's ok. This is found on your master cylinder (wheel brakes area)

U should pull the break strap it may balanced the height.