20 Most Recent
2011 Mitsubishi L200 2.5 Questions & Answers
Battery and fuel water light on,alternator overcharging
Don't know much about your vehicle but sounds like you may have an external voltage regulator...need to find out no matter how many alternators you change if the regulator is allowing too many Amps and voltage out..you could damage the entire charging system including the battery..confirm what your car has can checked to see if the alternator you bought has an internal reg also have your auto store go in computer an see if in deed you can order an external one for your car..if available you know it does have one or not.. But overcharge is all in the regulator..good luck..
Mitsubishi L200 overheating
i have an l200 animal, i started getting the same symptoms, bubbling noises, over heating, water being discharged into the header tank, i had a good look around the engine,there was no oil in the water or water in the oil ( signs of head gasket failure) when the radiator cap was off and i revved hard nothing happened, no dip in water levels and no splashing out. i took the water pump off and the impellor had sheered off the shaft. fitted a new pump and its been fine, maybe all these cracked cylinder heads and warped heads are to do with the engine being run with the fault not being cured.
How to replace BCM on Saturn 2003 L200
You take it to the dealer ! Need's to be programmed .
Body Control Module (BCM) Programming/RPO Configuration
The body control module (BCM) must be programmed with the proper RPO configurations. The BCM stores the information regarding the vehicle options and if the BCM is not properly configured with the correct RPO codes, the BCM will not control all of the features properly. Ensure that the following conditions exist in order to prepare for BCM programming:
• The battery is fully charged.
• The ignition switch is in the ON position.
• The data link connector (DLC) is accessible.
• All disconnected modules and devices are reconnected before programming.
To setup a new BCM, use the Tech 2 in conjunction with the Saturn Service Stall System . Refer to Service Programming System (SPS) in Programming.
If the BCM fails to accept the program, perform the following steps:
• Inspect all BCM connections.
• Verify that the scan tool has the latest software version
Not finding what you are looking for?