20 Most Recent 2008 Ford Focus - Page 7 Questions & Answers

Look in your manual and see how to reprogram the tire pressure sensors. At least I would start with that.

THE DEFROST IS CONTROLED BY A ELEC MOTOR THAT OPENS AND CLOSES A DOOR

give it some gas when it starts if stays running replace iac motor if not check maf sensor reading should be 6-8 grams per second.

check the dash dimmer switch it might be turned on.

service light is on with this spanner sign and as its a late vehicle after 2005 then only dealer software can put it out so its a service at the dealer if you want it put out iam afraid

I have the same problem few days ago, and still didn't find any solution. Can any one please help?????5

Hello, The Vibration in the brake pedal was likely the Antilock brake unit starting to work. It works when the 4 wheel sensors detect that the wheels are moving at different speeds from each other. This reduces skidding and pulling from a locked up wheel.

You need to have the Brake pads checked for wear. The rear brakes can have an additional problem because there are 2 sets of brakes in back, the Service brakes and the Emergency brakes. Sometimes the pads come unglued from their mounts and jiggle loosely in their holders.

Your Brake booster is also questionable along with the Master cylinder. This can explain the lack of power assist when you press on the brake pedal. While your problem can be all of these things, if only 1 or 2 are bad, you may not need to buy everything.

There are electric tests available for the ABS unit for Diagnosis. The rest require a manual and visual evaluation. I hope my Solution is very helpful towards fixing your problem.

sounds like the rods aren't connected inside, when you had it apart did it work