Appliance Expert
MasterTech posted an answer for this GE Televison & Video:
"The model you listed is for a Ge Electric Range. If the control panel is dead, there is no..."
MasterTech posted an answer for this Washing Machines:
"You can't bypass the lid locks on the cabrio models. You can but you have to do some..."
MasterTech posted an answer for this Disney Televison & Video:
"Yes you can find them on ebay, I linked to a listing below that has all of them for sell..."
MasterTech posted an answer for this Whirlpool Washing Machines:
"If the door lock is not engaging the control will not allow a cycle to start as a safety..."
MasterTech posted an answer for this Whirlpool Washing Machines:
"When the washer was started with no water pressure it went in to a no water error mode...."
MasterTech posted an answer for this Washing Machines:
"I will need the full model number to give the replacement part info you need,. Open the..."
MasterTech posted an answer for this Maytag Dryers:
"The start contacts in the dryer timer are welded together, the timer will have to be..."
MasterTech posted an answer for this Maytag Dryers:
"Unfortunately the problem you are having is caused by a failed main control board, the..."
MasterTech posted an answer for this Whirlpool Washing Machines:
"The F01 error code usually means the main electronic control board has failed and will..."
MasterTech posted an answer for this Kenmore Oasis HE 27082 Top Load Washer:
"Actually the F51 error code can be caused by quite a few different things below is a step..."
MasterTech posted an answer for this Kenmore Elite Oasis 27052 Top Load Washer:
"The F51 error on the Cabrio, Oasis and Bravos are all the same error and can be quite a..."
MasterTech posted an answer for this Kenmore Oasis HE 27082 Top Load Washer:
"That Oasis Error can be quite a few different problems, below is link that will show you..."
MasterTech posted an answer for this Kenmore Elite Oasis 27052 Top Load Washer:
"The F51 error on the oasis could be several things, drive motor, rps sensor, mechanical..."
MasterTech posted an answer for this Whirlpool WTW4800XQ Washer:
"It could be either the control board or a bad actuator if it goes through sensing, fills..."
MasterTech posted an answer for this Washing Machines:
"That error is a motor tachometer error and the troubleshooting will depend on the model..."
MasterTech posted an answer for this Washing Machines:
"That error means either the main board is bad or the temperature sensor is bad, most..."
MasterTech posted an answer for this Kenmore Washing Machines:
"That washer is actually built by LG even though it has the kenmore name brand on it most..."
MasterTech posted an answer for this Washing Machines:
"Not sure what kind of washer you are talking about since you did not specify but if you..."
MasterTech posted an answer for this Washing Machines:
"If the washer is not filling with enough water then the water level pressure switch is..."
MasterTech posted an answer for this Washing Machines:
"Depending on the model of the washer you have it could be a different things causing that..."
MasterTech posted an answer for this Washing Machines:
"That error means there is a communication error between the central control unit and the..."
MasterTech posted an answer for this Refrigerators:
"That issue is caused by a stopped up defrost drain, when the unit defrosts the water goes..."
MasterTech posted an answer for this Samsung Refrigerators:
"Yes that would do it the temperature sensor / thermister sends the info to the control..."
MasterTech posted an answer for this Amana AOGD2750 Gas Double Oven:
"That error means the main control board has a internal failure. The board will have to..."
MasterTech posted an answer for this Kenmore Ovens:
"Hello there not sure if you need a user manual or a service manual but you can visit the..."
MasterTech posted an answer for this Bosch Ovens:
"Hard to say without the model number of the unit you can visit the site below and give us..."
MasterTech posted an answer for this Whirlpool Ovens:
"Most commonly that is a runaway temperature error which usually means the temperature..."
MasterTech posted an answer for this Kenmore Dryers:
"It depends on the model on some models they have a belt switch so that when the belt..."
MasterTech posted an answer for this Whirlpool LEQ8000JQ Electric Dryer:
"Yes that is indicative of a bad motor, replace the motor and that will take care of the..."