Waterway Pool & Spa - Recent Questions, Troubleshooting & Support
Need plumbing diagrams for wilderness camper
RV water lines can sometimes be difficult to locate. But typically, by removing a panel or an accessible flooring section, Youcan successfully gain access to most of the fresh water plumbing system. The clue to a removable panel is to look for screws instead of staples holding them in place
Remove impeller from Waterway 502n22c
To remove the impeller you first take the front face plate off to expose the impeller. Then isolate the shaft from the motor with a pair of needle nose vise grips and using a pair of channel lock pliers grip the end of the impeller and rotate counter clockwise to un thread it from the shaft. If the shaft seal has been leaking there may be to much corrosion to turn the impeller in which case it needs to be broken off.
How do I replace a waterway executive 56 fuse
There is no fuse in the pump itself. Pump fuses are located in the control pak where the pump cord is attached. Turn off the power to the spa and remove the cover of the pak. There is usually a diagram of the board showing where the fuses are. Pump fuses are not clear they are about 1 1/4" long and have a label on them with the rating of the fuse. Usually 20 or 25 amps and either SC or AG rating
Not finding what you are looking for?