LG Home Applaince Popular Questions, Answers, Tips & Manuals

There is a switch inside the unit that stops it when the belt breaks or comes loose. Check that.

should check ur moister sensor with a meter and check the hi limit and cycling thermostat fuses

check drum belt, safety fuses and door switch..

There are three high limit thermostats. Check all three for continuity. They should read closed (0 ohms). Check the flame sensor. They're cheap so you could just replace. It needs to close before the first solenoid opens and then open before the second solenoid opens. Again, easier to replace. Check continuity on the solenoid coils. They should read 1.5 K ohms. I replaced two gas valves before I recognized a "new" gas valve might not be really new.

unplug the dryer,remove the top panel,remove the control panel,usually a couple of screws on the top right and left side,when you get the control panel off there are like 4 screws on the top front panel then open the door and remove 2 more screws,disconnect door switch.go here this will help you out i'm trying to go by memory and it's harder to remember how to do it,when i'm in front of it i can pull it apart no problem but this should help you out.http://www.youtube.com/watch?v=RvbJn61d9hQ

Make sure it has good air flow

Hello KrazyIf your dryer tumbles, but there is no heat. You need to check this following:Check for proper air flowTest the safety fuseTest the thermostatsTest the centrifugal switchTest the timer motorTest the heating elementBest RegardsNeciforo Llanto

Generally speaking no. It might be the control board or the power supply or the control panel that is bad. You can take the top off and there should be a set of technician instructions that say what to test.

Lot of these dryer had a split or defect in the drum. They will give a free drum but ya gotta pay labor to replace it. MY LG dryer service manuals and repair videos If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

the usual cost is about $500 - $600 if you call A&E FACTORY SERVICE $700 - 1.000.00 if you call Appliance Unlimited I thank you should get a all new unit instead of fixing it

OK, you will need to replace the center post seals. The parts are less than $10.00 but you will need a special tool to get the basket out. Let me know if you want to tackle this job yourself and I will direct you to the parts and the tool and a video to walk you thru the repair. A service call for this will be anywhere from $100.00 to $150.00. Keep me posted!

The windings in the motor are bad and the motor will need to be replaced. Here is the motor to order.The part comes with a 365 day, any part, any reason return policy.

Check all the internal and external duct work for lint buildup and blockage.

with any kind of electrical burning smell you should call a technician. The smell could be generated from either the control panel being shorted or the motor itself overheating and burning the one of the windings out. If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3