Generac Electrical Supplies - Page 3 - Recent Questions, Troubleshooting & Support
13w guardian generac generator 054960 doesn't charge battery
Check "F1" fuse.
If fuse is good, check voltage at battery.
With either utility power present or generating running, the voltage at the battery should be >13VDC. Any reading less than 12.7VDC is battery voltage and indicates a failed charging circuit.
10/23/2019 5:47:23 PM •
Generac...
•
Answered
on Oct 23, 2019
Generac 43903 standby Generator overspeed indicator on starting
I have a generator that did the same thing. It would start and then stop within a few seconds. The more expensive generators have an oil level safety switch to prevent the engine from burning up. There is usually a wire connecting to the switch on the outside of the engine near the oil fill hole. Remove this wire and try to start the generator. If it runs without a problem then it is the switch. You need to remove the switch and take it apart carefully and clean it. There is a small float inside the assembly. When the oil runs low the float allows the switch to short to ground which kills the spark to the spark plug. Hope that helps.
Bob Janelli I’m happy to help further over the phone at
https://www.6ya.com/expert/bob_62dfa2f81bb55288
My Generac generator model 10kw starts it's exercise timer, runs but won't shut off. Any ideas?
It is common to cut off the fuel supply by stopping the diesel engine to shut off the transmission of fuel or air. The method is to install the solenoid valve on the pipeline of oil or gas supply, and control the opening and closing of the solenoid valve by pressing the electric button. So the solenoid valve is out of control. It can't cut off the fuel and air.
More technology supports, suggest you to contact the Starlight manufacturer( diesel generator set), they supply Cummins, Volvo, Perkins generator and provide services supports, the email address:
[email protected].
9/21/2019 6:59:59 AM •
Generac...
•
Answered
on Sep 21, 2019
Not finding what you are looking for?