Creda Ovens - Recent Questions, Troubleshooting & Support

It needs a new controller, or if electronic, a thermistor or the whole control board. Easier job if it is the type with a knob, not so easy if an electronic appliance and those parts are expensive so call for service to correctly identify.

wired wrong to the breakers seems to me. read the oven spec, on amps max the see if your breaker can do those amps then deal with that. if wrong or call and electrician to fix it. page 5 in your manual (UK?) states The cooker must be connected by a competent person such as one who is a, NICEIC registered contractor to a suitable double-pole control unit with a minimum rating of 32A and a minimum contact clearance of 3mm (applicable to newer properties, older properties where a 30A double pole control unit and a minimum contact clearance of 3mm is acceptable). The double pole control unit should be fitted adjacent to the cooker, in accordance with IEE regulations. The control unit must be within 2 metres of but not directly above the appliance and should be easily accessible in the event of an emergency. The power supply cable should conform to B.S.6004 with a conductor size of 6mm2 (we call that wire gauge) , minimum.!!! nothing smaller allowed in copper diameter. Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing

Check the main oven element for continuity with a multimeter. Probably needs a new element.

do you mean there isnt any power going to it or it dosent heat up or it just gets warm more detail please

Hold down the 2 left buttons together, and press the + or - button at the same time..
This should reset the timer.
Please leave a fixya rating for my solution.
Thanks.

There should be a Data tag with model & serial numbers send us that we can look it up

call an electrician to check the circuit insulation for shorts could be vermin cooked across electrical terminals , failing insulation, grease /fat across terminals dead shorts trip the breaker immediately, ground leakage problems take a little longer