My charbroil grill isn't running at full power
Your venturi could be clogged up. clean the burner holes with a straightened paperclip, then take the burners out and do the same to the venturi that deliver gas to the burners. If that doesn't do it, you may have a bad regulator.
2/26/2018 10:30:03 PM •
Char-Broil...
•
540 views • 0 helpful votes
I cannot get the gas grill to light. The tank was
the regulator could have gone into lock up.
try this to unlock it...
- Open the BBQ Lid
- Turn ALL main control knobs to the "OFF"/CLOSED position
- Turn the Propane tank valve to the "OFF"/CLOSED position
- Disconnect the Regulator hose from the Propane tank
- Turn ALL main control knobs to the "ON"/OPEN position
- Let stand for 1-2 minutes, allowing all excess gas in valves and manifold to dissipate
- Turn ALL control knob back to the "OFF"/CLOSED position
- Reconnect the regulator hose to the Propane tank- hand tighten only.
- Check all hose connections to ensure that a positive seal has been made
- SLOWLY turn "ON"/OPEN the propane gas supply
- Wait approximately 5 seconds for the regulator pressure to stabilize
- Turn "ON"/OPEN the selected burner control knob to "HI"
- Press the Multi Spark ignition button or match light selected burner.
- Hope this helps you has me in the past!
1/8/2018 6:51:03 PM •
Char-Broil...
•
579 views • 0 helpful votes
Gas Grill Burners with yellow flames coming from beneath them
the flames should be blue and the burners clean. check gas pressure and the air mixture dampers. touch air will give you the same effect. if the burners are clean, it is the mixture. as far as the slots in the bottom. i have not seen that. but i work on commercial ranges.
2/27/2017 3:12:02 AM •
Char-Broil...
•
1,216 views • 0 helpful votes
Where can I order the char broil symbol tag to replace on my BBQ grill?
from,,,,,,,,,,,,,,,,,,charbroil
7/27/2015 1:36:29 AM •
Char-Broil...
•
228 views • 0 helpful votes
Not finding what you are looking for?